I need a vacuum port diagram for a holley 4160 600cfm...
#1
Le Mans Master
Thread Starter
I need a vacuum port diagram for a holley 4160 600cfm...
It's an electric choke, vacuum secondary 4160 600cfm holley squarebore. I need to know where my vacuum advance connects and were my PCV connects. Thanks guys!!
#2
Safety Car
Member Since: Sep 2001
Location: modland CT
Posts: 4,095
Likes: 0
Received 0 Likes
on
0 Posts
Re: I need a vacuum port diagram for a holley 4160 600cfm... (TIMSPEED)
you are keeping the choke? it fits under the hood with the choke? you must have a low intake if so..... :confused: i had to mill the airhorn off to fit under my hood.....good luck. :cheers:
#3
Le Mans Master
Thread Starter
Re: I need a vacuum port diagram for a holley 4160 600cfm... (yoslambo1@cs.com)
EDIT: OOPS! Mod's can you put this in C3 Corvette please...I must have hit the wrong button. Sorry! :bb
[Modified by TIMSPEED, 10:34 AM 3/13/2003]
[Modified by TIMSPEED, 10:34 AM 3/13/2003]
#4
Safety Car
Member Since: Sep 2001
Location: modland CT
Posts: 4,095
Likes: 0
Received 0 Likes
on
0 Posts
Re: I need a vacuum port diagram for a holley 4160 600cfm... (TIMSPEED)
sorry i cant help....my engine builder made me remove the vaccume advance in case of detination! :eek: :confused:
#5
Safety Car
Member Since: Feb 1999
Location: Fountain Hills AZ
Posts: 3,625
Likes: 0
Received 10 Likes
on
10 Posts
Re: I need a vacuum port diagram for a holley 4160 600cfm... (TIMSPEED)
If it's a later model 4160, there should be 2 small ports on the passenger's side front. The upper port (on the metering block by the idle mixture screw) is for ported vacuum advance. Below that, on the base plate, is the same size port that is unported manifold vacuum. Towards the rear of the carb on the sam side is a large port for PCV.