Front licencse plate bracket
06-17-2013, 06:25 AM
#1
Instructor
Thread Starter
Front licencse plate bracket
Does anybody know where I can get a nice looking front bracket, for C6.
06-17-2013, 06:38 AM
#2
Last edited by R&L's C6; 07-04-2013 at 08:53 PM.
06-17-2013, 07:27 AM
#7
Team Owner
If you are going to get one this is the best out there.
06-17-2013, 09:03 AM
#11
1st Gear
Member Since: Mar 2005
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Front License Plate
Take a look at the 'Show n Go' License Plate Frame. I put the remote controlled one on my new C6 and really like it.
http://www.amazon.com/s/?ie=UTF8&key...l_7hh2i79d28_b
http://www.amazon.com/s/?ie=UTF8&key...l_7hh2i79d28_b
06-17-2013, 09:50 AM
#12
Race Director
i live in pa., thank god i don't need a front bracket for my car. THOSE THINGS ARE REAL UGLY. i think i would get the motorized one, no doubt. if i had to pay 500 to hide it, i would. sorry guy's, jmo.
06-17-2013, 11:47 AM
#13
Take a look at the 'Show n Go' License Plate Frame. I put the remote controlled one on my new C6 and really like it.
http://www.amazon.com/s/?ie=UTF8&key...l_7hh2i79d28_b
http://www.amazon.com/s/?ie=UTF8&key...l_7hh2i79d28_b
06-17-2013, 01:19 PM
#14
Instructor
Made two little angle brackets for the top of the plate. I mounted them at the top of the grille (sandwiched the grill between the bracket and bracket backing plate....no grille damage or holes to drill). I have a small aluminum angle bracket at the bottom attached to the license plate and body with double foam tape...license frame is close to, but not touching the body (again, no holes or damage). This angles the plate back under the body overhang at the top with the bottom overhanging the body slightly at the bottom. Looks good (as good as a front plate can) and better than the available brackets IMO. Cost wasn't really a factor, just didn't like what was available.
06-17-2013, 01:30 PM
#15
Instructor
Member Since: Jan 2011
Location: Crozet VA
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
I just installed the one from Zip. IMO the ones that put the plate right square in the center look awful. The Zip one is a little offset to the driver's side, and really low. And, it is very, very easy to remove and put back on if you want to.
06-17-2013, 02:21 PM
#16
Racer
Member Since: Dec 2005
Location: Black Diamond Washington
Posts: 323
Likes: 0
Received 1 Like
on
1 Post
I have Show-n Go and as you can see I keep it tucked under, most of the time. If I get stopped, only happned once I say just washed the car and forgot to put it out.
I don't like it for the reason the car is so low it hits all the time, speed bumps, drive ways also the motor is weak and a little dirt on it and it doesn't move.
