10-PCM - No Comm
10-09-2010, 04:19 PM
#1
Burning Brakes
Thread Starter
Member Since: Oct 2007
Location: Long Island New York
Posts: 1,117
Likes: 0
Received 4 Likes
on
4 Posts
10-PCM - No Comm
Started the car today and the car just stops and stalls in my driveway.
messages on the display -
Reduce Engine Power
Service Traction System
Service Vehicle Soon
Service ABS
Ran the codes and got a code 10-PCM - No Comm
Does this mean my computer is screwed up?
I'm stuck with the car in my dirveway, car cranks and won't start.
Any help is appreciated, Any Long Islanders around that can help?
Thanks
Bruce
messages on the display -
Reduce Engine Power
Service Traction System
Service Vehicle Soon
Service ABS
Ran the codes and got a code 10-PCM - No Comm
Does this mean my computer is screwed up?
I'm stuck with the car in my dirveway, car cranks and won't start.
Any help is appreciated, Any Long Islanders around that can help?
Thanks
Bruce
10-10-2010, 08:47 AM
#2
Burning Brakes
Thread Starter
Member Since: Oct 2007
Location: Long Island New York
Posts: 1,117
Likes: 0
Received 4 Likes
on
4 Posts
Thanks
This is my job today, I'll keep you posted
This is my job today, I'll keep you posted
If the BCM and PCM cannot communicate you are going no where.
Check the battery and battery cables to make certain cables are clean and tight and that the battery voltage with the Neg battery cable disconnected is greater than 12.5 volts. Also start checking grounds. Here is a link to a Bill Curlee thread about the grounds:
http://forums.corvetteforum.com/c5-t...tion-long.html
Check the battery and battery cables to make certain cables are clean and tight and that the battery voltage with the Neg battery cable disconnected is greater than 12.5 volts. Also start checking grounds. Here is a link to a Bill Curlee thread about the grounds:
http://forums.corvetteforum.com/c5-t...tion-long.html
