rare casting#492 SBC double hump heads
#1
Burning Brakes
Thread Starter
Member Since: Feb 2007
Location: Eagle Rock Missouri
Posts: 1,015
Likes: 0
Received 0 Likes
on
0 Posts
rare casting#492 SBC double hump heads
I have a set of double hump 2.02 1.60 angle plug heads. The heads just got completely redone , 3 angle valve job, magnafluxed, milled , ported and are ready to install. These are pretty rare heads and were only available from GM performance over the counter. These have the accessory holes drill, comp springs, guide plates, studes, self aligning rockers. I want to sell these for 600.00 or trade for some 64cc aluminum heads or vortec heads. The only reason I am selling is cause my motor has to much compression to run pump gas 417 846 5058 or dcmock@centurytel.net
Last edited by dcmock; 03-22-2010 at 06:35 PM.
#2
Melting Slicks
How far were they milled, or what is the current combustion chamber volume?
Originally, these heads were stock with ~64cc.
Originally, these heads were stock with ~64cc.
#3
Race Director
Member Since: Mar 2009
Location: Canada's capital
Posts: 19,777
Received 4,583 Likes
on
2,157 Posts
2020 Corvette of the Year Finalist (appearance mods)
C1 of Year Finalist (appearance mods) 2019
Bought a set from GM in the 70's, paid about a grand back then! You had to buy them bare and load them up. Best heads I ever had, and....changing the plugs with full headers was a breeze with those angled plugs. No problems with ign. wires too close to the heat. $600 is very fair IMHO.
#4
Team Owner
Member Since: Jan 2007
Location: cookeville tennessee
Posts: 28,846
Received 1,762 Likes
on
1,529 Posts
Bought a set from GM in the 70's, paid about a grand back then! You had to buy them bare and load them up. Best heads I ever had, and....changing the plugs with full headers was a breeze with those angled plugs. No problems with ign. wires too close to the heat. $600 is very fair IMHO.