What did I do to my motor? :(
#81
Melting Slicks
#82
Race Director
Thread Starter
#90
Race Director
Thread Starter
#92
Instructor
Member Since: Dec 2006
Location: Phoenix AZ
Posts: 244
Likes: 0
Received 0 Likes
on
0 Posts
Ya ..it just takes a lil tap to bend a valve
Glad you didn't blow holes into the pistons (seen that too)
I always replace with better than I had.. good time to take a hard look at what you can do aka how crazy can you get
-Frank
Glad you didn't blow holes into the pistons (seen that too)
I always replace with better than I had.. good time to take a hard look at what you can do aka how crazy can you get
-Frank
#93
Instructor
Member Since: Aug 2007
Location: DFW Big State Of Texas
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for the bad outcome but look at it this way new forged top end enables more boost.
Last edited by PFMC3; 11-13-2007 at 08:27 PM.
#95
Why don't you just pop a plug out, and check the compression. That will rule out just about everything 'mechanical'. Pulling the engine at this point is a little pre-mature in my opinion.
As Bill Curlee stated, start with the basics...Spark, fuel and compression. All of these can be easily accomplished with minimal tools and time.
At least that's my thoughts.
As Bill Curlee stated, start with the basics...Spark, fuel and compression. All of these can be easily accomplished with minimal tools and time.
At least that's my thoughts.
Good luck man, if your gonna do it, GO ALL THE WAY! Fordge that bastard and kick up the boost.. ps: get an LS2 chain.
#98
Race Director
Thread Starter
I just want to thank everyone for all their help. Especially you local guys, offering parts up and all, just a class act. It makes me even more proud to own a Corvette and be part of the Corvette community even when things aren't looking so well.
I have my fingers crossed that the car will be back together and tuned by this weekend. I am going the economy route at this time and just doing repairs. I still really want to go forged but could not fit it in the budget at this time. There will be a day........
I have my fingers crossed that the car will be back together and tuned by this weekend. I am going the economy route at this time and just doing repairs. I still really want to go forged but could not fit it in the budget at this time. There will be a day........
#99
Le Mans Master
Corey is having a B-B-Q and Car Show at Henderson Performance Technologies on Sun., November 18 from 9AM-3PM.
This is to benefit Blue Santa and they are accepting unwrapped toys and cash donations. You should come by, and if your cars not finished it will let you look in on it...
This is to benefit Blue Santa and they are accepting unwrapped toys and cash donations. You should come by, and if your cars not finished it will let you look in on it...