L98 to LT1 intake conversion?
#2
Advanced
Member Since: Aug 2005
Location: Elgin Minnesota
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Check This Link
This link should tell you all you need. I didn't like the way you have to run the remote thermostat, but thats just me!
http://www.lt1intake.com/services.htm
http://www.lt1intake.com/services.htm
#4
Le Mans Master
Member Since: Apr 2000
Location: Shelton CT
Posts: 6,341
Likes: 0
Received 0 Likes
on
0 Posts
Search on the THIRDGEN.ORG forum. Few people tried, even fewer got it to work successfully using a converted LT1 intake..
Good idea, I'd be doing it if it didn't mean no Emissions, chances of eaten distrbutor gears and coolant leaks, remote thermostat , need for smaller distributor, etc..
Good idea, I'd be doing it if it didn't mean no Emissions, chances of eaten distrbutor gears and coolant leaks, remote thermostat , need for smaller distributor, etc..
#5
I have a conversion, I did most of the work myself with the exception of welding extra metal around the water jacket for extra insurance (no leakage) the advantage of a conversion is to allow the engine to pull more air at high RPM, if you have head work and a higher revving cam you will see a BIG differents. I pickup 5 mph in the 1/4 doing it, which result in 50 hp or more doing that. check my web page
Randy
Randy
#6
Advanced
Member Since: Oct 2004
Location: Toms River NJ
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
I am in the process of doing the same thing. Randy, how did you get the bigger distributor to fit? Did you machine the egr ports off? I am considering doing that because I don't want to set it up for remote coil application.
#7
Le Mans Master
Member Since: Aug 2000
Location: Sydney Australia
Posts: 8,837
Likes: 0
Received 30 Likes
on
29 Posts
Working on one at present.
If you cut away EGR boss completely you only have to cover a hole 1.5 x 2 where the exh gas went under the runners.You will need custom lines ( a -AN fitting on each rail )with the large HEI as the large cap won't clear the stock lines.
As above I am going to weld extra material above the stock water jackets as there is little room for error and the LT1 manifold is a lot lower than stock in these areas.
Have pics if you want to email me
vetteoz@optusnet.com.au
If you cut away EGR boss completely you only have to cover a hole 1.5 x 2 where the exh gas went under the runners.You will need custom lines ( a -AN fitting on each rail )with the large HEI as the large cap won't clear the stock lines.
As above I am going to weld extra material above the stock water jackets as there is little room for error and the LT1 manifold is a lot lower than stock in these areas.
Have pics if you want to email me
vetteoz@optusnet.com.au