[Z06] Elite Engineering Catch Can Hose Connections
#1
CF Senior Member
Thread Starter
Elite Engineering Catch Can Hose Connections
I have searched the forum and haven't found a good set of install pictures for the Elite Engineering Catch Can on the LS7. My big question is how the hose connections go. From the top of the Catch Can to the engine, does this connection go to the top connector or the bottom connector on the LS7? I do not want to mix up the connections. Do the hoses line up (top of catch can to top connector on LS7)? Then the two bottoms to each other.
#3
CF Senior Member
Thread Starter
#4
CF Senior Member
Thread Starter
Which person has their connections correct? It seems by searching on this forum, I can find people installing their Catch Can hoses both ways.
Top to Top
Top to Bottom
Top to Top
Top to Bottom
#5
Which person has their connections correct? It seems by searching on this forum, I can find people installing their Catch Can hoses both ways.
Top to Top
Top to Bottom
Top to Top
Top to Bottom
#6
Which person has their connections correct? It seems by searching on this forum, I can find people installing their Catch Can hoses both ways.
Top to Top
Top to Bottom
Top to Top
Top to Bottom
#7
#8
CF Senior Member
Thread Starter
#10
CF Senior Member
Thread Starter
#11
Team Owner
Got your PM. Glad to see you've been linked to the correct instructions. Let me know if you have any more questions.
Paul
#12
no i didnt use the clamps... theres no need too plus from the factory theres no clamps.... push the hose on the barbed connectors and ull see its hard to pull off... it aint ever blowing off