CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: 65GGvert
Showing results 1 to 25 of 492
Search took 1.22 seconds.
Forum: C1 & C2 Corvettes
Yesterday, 11:13 PM
Replies: 4
Views: 117
Posted By 65GGvert

Are you sure you had all three levels in the...

Are you sure you had all three levels in the neutral position when you had the linkage disconnected?
Forum: C1 & C2 Corvettes
Yesterday, 08:09 PM
Replies: 12
Views: 146
Posted By 65GGvert

The dimmer switch contacts may be a little dirty...

The dimmer switch contacts may be a little dirty or corroded and cycling cleaned them off. I was not aware of the radio connection at the headlight switch as it doesn't show on my diagram, but I...
Forum: C1 & C2 Corvettes
Yesterday, 07:30 PM
Replies: 12
Views: 146
Posted By 65GGvert

Is your radio an aftermarket device?

Is your radio an aftermarket device?
Forum: C1 & C2 Corvettes
Yesterday, 05:12 PM
Replies: 12
Views: 146
Posted By 65GGvert

The radio will not be on a fuse with the...

The radio will not be on a fuse with the headlight switch. The headlights don't use a fuse, except for the small one you mentioned on the switch which only protects the dash lights. Your headlight...
Forum: C1 & C2 Corvettes
Yesterday, 11:14 AM
Replies: 6
Views: 341
Posted By 65GGvert

Only the 67s were body colored

Only the 67s were body colored
Forum: C1 & C2 Corvettes
04-23-2024, 05:15 PM
Replies: 6
Views: 341
Posted By 65GGvert

Yes ...

Yes

https://cimg1.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/646x756/img_4396_a5cbc76a721c85d574d4d4b1b617df36f4d8e052.jpeg
Forum: C1 & C2 Corvettes
04-22-2024, 05:24 PM
Replies: 4
Views: 187
Posted By 65GGvert

It wasn't oil filled from the factory.

It wasn't oil filled from the factory.
Forum: C1 & C2 Corvettes
04-22-2024, 01:56 PM
Replies: 10
Views: 351
Posted By 65GGvert

Read through the earlier posts. One big advantage...

Read through the earlier posts. One big advantage is running cooler at idle. All the information needed has been provided in detail in this thread.
Forum: C1 & C2 Corvettes
04-21-2024, 09:48 AM
Replies: 10
Views: 351
Posted By 65GGvert

Manifold.

Manifold.
Forum: C1 & C2 Corvettes
04-17-2024, 11:37 PM
Replies: 6
Views: 278
Posted By 65GGvert

A lot of reasons that won't work for you. The...

A lot of reasons that won't work for you.
The micro switches and wires aren't able to handle the current of the headlight motors over time.
Once the buckets roll full open, the microswitches will...
Forum: C1 & C2 Corvettes
04-17-2024, 04:54 PM
Replies: 71
Views: 13,632
Posted By 65GGvert

https://cimg8.ibsrv.net/gimg/www.corvetteforum.com...

https://cimg8.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/1300x889/image1_26060fbc3cee5caa765bfb59e20ee39328c96c11.jpg
Forum: C1 & C2 Corvettes
04-16-2024, 11:47 PM
Replies: 20
Views: 726
Posted By 65GGvert

Brushed just enough to move any flakes, a few...

Brushed just enough to move any flakes, a few minutes each and then painted with small brush without removing manifolds. The can says it works best over rust. Don't let it dry on your hands and wear...
Forum: C1 & C2 Corvettes
04-16-2024, 07:27 PM
Replies: 20
Views: 726
Posted By 65GGvert

I’ve done three sets with the Por-15 and still...

I’ve done three sets with the Por-15 and still have half a can left. I didn’t bake anything. I just drove the cars to cure them as the can says.
Forum: C1 & C2 Corvettes
04-16-2024, 05:11 PM
Replies: 20
Views: 726
Posted By 65GGvert

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com...

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/2000x1504/_storage_emulated_0_dcim_camera_img_20191124_202142442_3eb93a75b57a01324d7caf4cc36b3365b437bd47.jpeg
Forum: C1 & C2 Corvettes
04-16-2024, 05:03 PM
Replies: 20
Views: 726
Posted By 65GGvert

I can tell you for a fact that brush on Por-15 in...

I can tell you for a fact that brush on Por-15 in manifold gray is an excellent product.
I would use nothing else on my exhaust manifold. I also use it on my master cylinders. If something happens...
Forum: C1 & C2 Corvettes
04-16-2024, 06:39 AM
Replies: 8
Views: 316
Posted By 65GGvert

If your 67 doesn’t have its tank sticker, you’re...

If your 67 doesn’t have its tank sticker, you’re out of luck. No such numbers are available for C2’s.
Forum: C1 & C2 Corvettes
04-15-2024, 06:55 PM
Replies: 21
Views: 724
Posted By 65GGvert

The horn is the tip off. If the horn stops...

The horn is the tip off. If the horn stops working and then starts working when you mess with the battery cable, then you’re in the right area.
Forum: C1 & C2 Corvettes
04-15-2024, 02:59 PM
Replies: 2
Views: 144
Posted By 65GGvert

There is a longer brown wire on 64/65 rear...

There is a longer brown wire on 64/65 rear harness that connects to the dash fan heater switch. It provides 12v to the rear exhaust fan when the dash fan switch is in the off position. I don't know...
Forum: C1 & C2 Corvettes
04-15-2024, 12:16 PM
Replies: 21
Views: 724
Posted By 65GGvert

It won't be the battery. This connection feeds...

It won't be the battery. This connection feeds all power to the cabin. When it happens again, you'll find if you just wait a few OR slightly wiggle this bulkhead connector the car will work again for...
Forum: C1 & C2 Corvettes
04-15-2024, 09:08 AM
Replies: 4
Views: 186
Posted By 65GGvert

Are you still using the tach drive distributor?...

Are you still using the tach drive distributor? Or has it been converted to an electronic tach? Try it again and post your RPMs in third fourth and fifth at the same speed
Forum: C1 & C2 Corvettes
04-14-2024, 01:37 PM
Replies: 11
Views: 257
Posted By 65GGvert

Don’t let it flip like that. When it’s cold, hold...

Don’t let it flip like that. When it’s cold, hold the choke blade open open the throttle and very slowly let it move through the motion to close to see if there’s any resistance. Once you snap it...
Forum: C1 & C2 Corvettes
04-14-2024, 11:18 AM
Replies: 8
Views: 317
Posted By 65GGvert

Google the instructions for whatever you are...

Google the instructions for whatever you are installing.
Forum: C1 & C2 Corvettes
04-14-2024, 09:57 AM
Replies: 18
Views: 583
Posted By 65GGvert

again, if the pins don’t do anything, what...

again, if the pins don’t do anything, what difference would it make if you were changing it on the side of the road? If you try to pull the pin out and it’s jammed because the spinner tried to move...
Forum: C1 & C2 Corvettes
04-14-2024, 09:51 AM
Replies: 11
Views: 257
Posted By 65GGvert

Choke should work the same with or without it. It...

Choke should work the same with or without it. It would just warm up a little faster, don’t worry about whether the heat riser is working until you get the choke working. It would not change your...
Forum: C1 & C2 Corvettes
04-14-2024, 06:58 AM
Replies: 11
Views: 257
Posted By 65GGvert

The position of the choke plate determines fast...

The position of the choke plate determines fast idle step, so do this and report back. Engine off and cold, open the throttle and the choke should close completely. Still holding the throttle open...
Showing results 1 to 25 of 492
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 07:42 AM.