408ls2 queston???!?!?!?
#1
Pro
Thread Starter
408ls2 queston???!?!?!?
I just bought an ls2 shortblock and dropped it off at the machine shop to get it built, queston is can I bore the aluminum block to a 408? I plan on making 800hp+ on the engine and wasn't sure if it would be safe? It is a FI setup and will be running around 15lbs of boost.
#2
What are you calling a short block? I call a short block the bottom half of the engine already assembled, piston, rods and crank (no heads).
I don't believe you can bore an aluminum block, but you can have it honed. My LS2 402 has a 4.01 bore and a 4 inch stroke. I think that's on the safe side for a hone, but you can call one of vendor sponsors TSP and ask them about it.
I don't believe you can bore an aluminum block, but you can have it honed. My LS2 402 has a 4.01 bore and a 4 inch stroke. I think that's on the safe side for a hone, but you can call one of vendor sponsors TSP and ask them about it.
#3
Drifting
What are you calling a short block? I call a short block the bottom half of the engine already assembled, piston, rods and crank (no heads).
I don't believe you can bore an aluminum block, but you can have it honed. My LS2 402 has a 4.01 bore and a 4 inch stroke. I think that's on the safe side for a hone, but you can call one of vendor sponsors TSP and ask them about it.
I don't believe you can bore an aluminum block, but you can have it honed. My LS2 402 has a 4.01 bore and a 4 inch stroke. I think that's on the safe side for a hone, but you can call one of vendor sponsors TSP and ask them about it.
#4
Melting Slicks<br><img src="/forums/images/ranks/3k-4k.gif" border="0">
Member Since: Nov 2002
Location: Jamison Pa
Posts: 2,841
Received 233 Likes
on
179 Posts
St. Jude Donor '11-'24
LS2 + 4" crank = 402
Bob K.
#5
Drifting
LS1/6 cranks can handle 1000hp. lol now if it were me id change it.....