CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: 65GGvert
Showing results 1 to 25 of 491
Search took 1.44 seconds.
Forum: C1 & C2 Corvettes
Yesterday, 06:55 PM
Replies: 11
Views: 225
Posted By 65GGvert

The horn is the tip off. If the horn stops...

The horn is the tip off. If the horn stops working and then starts working when you mess with the battery cable, then you’re in the right area.
Forum: C1 & C2 Corvettes
Yesterday, 02:59 PM
Replies: 2
Views: 92
Posted By 65GGvert

There is a longer brown wire on 64/65 rear...

There is a longer brown wire on 64/65 rear harness that connects to the dash fan heater switch. It provides 12v to the rear exhaust fan when the dash fan switch is in the off position. I don't know...
Forum: C1 & C2 Corvettes
Yesterday, 12:16 PM
Replies: 11
Views: 225
Posted By 65GGvert

It won't be the battery. This connection feeds...

It won't be the battery. This connection feeds all power to the cabin. When it happens again, you'll find if you just wait a few OR slightly wiggle this bulkhead connector the car will work again for...
Forum: C1 & C2 Corvettes
Yesterday, 09:08 AM
Replies: 4
Views: 160
Posted By 65GGvert

Are you still using the tach drive distributor?...

Are you still using the tach drive distributor? Or has it been converted to an electronic tach? Try it again and post your RPMs in third fourth and fifth at the same speed
Forum: C1 & C2 Corvettes
04-14-2024, 01:37 PM
Replies: 11
Views: 234
Posted By 65GGvert

Don’t let it flip like that. When it’s cold, hold...

Don’t let it flip like that. When it’s cold, hold the choke blade open open the throttle and very slowly let it move through the motion to close to see if there’s any resistance. Once you snap it...
Forum: C1 & C2 Corvettes
04-14-2024, 11:18 AM
Replies: 7
Views: 216
Posted By 65GGvert

Google the instructions for whatever you are...

Google the instructions for whatever you are installing.
Forum: C1 & C2 Corvettes
04-14-2024, 09:57 AM
Replies: 15
Views: 424
Posted By 65GGvert

again, if the pins don’t do anything, what...

again, if the pins don’t do anything, what difference would it make if you were changing it on the side of the road? If you try to pull the pin out and it’s jammed because the spinner tried to move...
Forum: C1 & C2 Corvettes
04-14-2024, 09:51 AM
Replies: 11
Views: 234
Posted By 65GGvert

Choke should work the same with or without it. It...

Choke should work the same with or without it. It would just warm up a little faster, don’t worry about whether the heat riser is working until you get the choke working. It would not change your...
Forum: C1 & C2 Corvettes
04-14-2024, 06:58 AM
Replies: 11
Views: 234
Posted By 65GGvert

The position of the choke plate determines fast...

The position of the choke plate determines fast idle step, so do this and report back. Engine off and cold, open the throttle and the choke should close completely. Still holding the throttle open...
Forum: C1 & C2 Corvettes
04-13-2024, 04:36 PM
Replies: 15
Views: 424
Posted By 65GGvert

If you truly think they “don’t do ANY good”, try...

If you truly think they “don’t do ANY good”, try to knock a spinner off with the pin in place. Nothing will save a wheel that’s been installed incorrectly on the adapter from loosening, but it...
Forum: C1 & C2 Corvettes
04-13-2024, 11:15 AM
Replies: 15
Views: 695
Posted By 65GGvert

Sorry, no.

Sorry, no.
Forum: C1 & C2 Corvettes
04-13-2024, 07:35 AM
Replies: 7
Views: 311
Posted By 65GGvert

This is an example, there are other vendors with...

This is an example, there are other vendors with speakers available:...
Forum: C1 & C2 Corvettes
04-13-2024, 07:19 AM
Replies: 7
Views: 311
Posted By 65GGvert

The plug will only connect one way. Yellow is 12v...

The plug will only connect one way. Yellow is 12v switched, gray is lamp, and black is ground. Make sure to connect the black ring terminal to the Z bar with a bolt (good to use a star washer also)....
Forum: C1 & C2 Corvettes
04-09-2024, 05:59 PM
Replies: 10
Views: 278
Posted By 65GGvert

Save yourself and your left leg a lot of trouble...

Save yourself and your left leg a lot of trouble and just leave the gorilla spring off. If you don’t like it you can always add it later. Read through the replies you’ve already gotten.
Forum: C1 & C2 Corvettes
04-09-2024, 05:55 PM
Replies: 6
Views: 203
Posted By 65GGvert

Just so you know that doesn’t light the clock. It...

Just so you know that doesn’t light the clock. It has a regular bulb. That goes on the bulb that lights the bezel of the heater and air knobs. I’d leave it off. If you insist remove the passenger...
Forum: C1 & C2 Corvettes
04-09-2024, 07:09 AM
Replies: 10
Views: 278
Posted By 65GGvert

With the fingered pressure plate like you’ve got...

With the fingered pressure plate like you’ve got you don’t even need the gorilla spring. If you insist on using it, the procedure in the ST 12 Manual explains it. You loosen the bolt, move the upper...
Forum: C1 & C2 Corvettes
04-08-2024, 04:19 PM
Replies: 9
Views: 360
Posted By 65GGvert

I'd check timing and spark plugs before anything...

I'd check timing and spark plugs before anything else. Also, make sure your idle rpm isn't too high.
Forum: C1 & C2 Corvettes
04-08-2024, 08:42 AM
Replies: 5
Views: 199
Posted By 65GGvert

63-66 standard wheels were 15x5.5 “. 67...

63-66 standard wheels were 15x5.5 “.
67 standard rally wheels were 15x6”.
none were 14” wheels.
Forum: C1 & C2 Corvettes
04-07-2024, 05:32 PM
Replies: 6
Views: 285
Posted By 65GGvert

PS Your roll pins don't look to short. If they...

PS Your roll pins don't look to short. If they are even slightly too long, they will rub when you tighten the wheel nut down. It's possible your flat spring under the turn signal lever the the pins...
Forum: C1 & C2 Corvettes
04-07-2024, 05:25 PM
Replies: 6
Views: 285
Posted By 65GGvert

Flip the wheel over so that when sitting in the...

Flip the wheel over so that when sitting in the driver's seat l looking at turn signal mechanism, the roll pins straddle the 9:00 position (toward the door)....
Forum: C1 & C2 Corvettes
04-07-2024, 11:57 AM
Replies: 40
Views: 1,384
Posted By 65GGvert

If you're absolutely sure the other lights are...

If you're absolutely sure the other lights are all working, and the bulb is good, look at the light blue wire that feeds through the connector on the steering column coming down from the turn signal...
Forum: C1 & C2 Corvettes
04-07-2024, 11:46 AM
Replies: 6
Views: 349
Posted By 65GGvert

Read post #3. ALL 63-66 steel wheels are 5 1/2"...

Read post #3.
ALL 63-66 steel wheels are 5 1/2" wide.
ALL knockoff, bolt-on knockoff, and 67 rally wheels are 6" wide.
Forum: C1 & C2 Corvettes
04-07-2024, 11:35 AM
Replies: 4
Views: 363
Posted By 65GGvert

To guide the dipstick toward the bottom of the pan

To guide the dipstick toward the bottom of the pan
Forum: C1 & C2 Corvettes
04-06-2024, 10:17 PM
Replies: 4
Views: 204
Posted By 65GGvert

https://forums.corvetteactioncenter.com/threads/he...

https://forums.corvetteactioncenter.com/threads/heat-valve-riser-questions.28399/
Forum: C1 & C2 Corvettes
04-06-2024, 10:02 PM
Replies: 4
Views: 204
Posted By 65GGvert

Wire the heat riser open and check the temps and...

Wire the heat riser open and check the temps and exhaust output, it should match the driver's side.
Showing results 1 to 25 of 491
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 05:45 AM.